The PL6850 is designed to provide stable power to support module reprogramming, ADAS recalibration, electronic repairs and diagnostic tasks
Overland Park, Kan.—Clore Automotive has introduced its new PRO-LOGIX Model PL6850, 12/24 Volt 120A Flashing Power Supply and 120/60/40/10A Battery Charger. The PL6850 is designed to provide stable power, on demand up to 120 amps, to a vehicle electrical system to support module reprogramming, ADAS recalibration, electronic repairs and diagnostic tasks.
It also provides full service 12/24V battery charging capabilityfrom 10 to 120 Amps, to service everything from small vehicle batteries to Group 31 multi-battery packs. In power supply mode, the PRO-LOGIX PL6850 provides power to maintain vehicle electrical system voltage at a preset level, increasing its output in response to system load increases to maintain a stable power environment for successful reprogramming.
It features a voltage output range of 13.1-14.9V (12V) or 26.1-29.8V (24V), adjustable in 0.1V increments. allowing the operator to dial the output in exactly as specified by the supplier of the vehicle under service.
It features fast load responsiveness for ultra-quick recovery from system demand increases. It also delivers its massive power with minimal voltage ripple (<100mV), providing a clean flow of power to the vehicle without risk of programming interference. In charging mode, the PL6850 utilizes advanced microprocessor-controlled logic to optimally charge each battery or battery pack serviced.
It features the ability to properly charge a wide variety of battery types, including Conventional, AGM, Spiral Wound, Start-Stop, Deep Cycle and Marine lead acid batteries, plus LiFEPO4 Lithium Batteries—enabling beneficial service of virtually any battery type installed in a vehicle.
It adapts its charging approach based on the needs of each battery or battery pack it services, include activating a soft start mode on deeply discharged batteries and a battery repair mode on older/distressed batteries.It also is effective on totally dead (0.0V) batteries with its forced start mode.
It features detachable and field-replaceable input cable and output leads. The #2 AWG output leads are 13’ long, enabling easy access to vehicle batteries/packs under any condition. The unit includes a handle for easy transport around a shop or in and out of a mobile service vehicle.
Comments are closed.